发布时间： 2019-12-18 Series: Product News Release Time: 2019-12-18
News Title: Different Material and Surface Inspection Requirements for Sheet Metal Processing
For sheet metal processing, the number of processing tolerances is large, so is the difficulty of processing larger or smaller? Are there some notes on different materials and sheet metal processing? Surface sheet metal processing audit, is it what you need to see? These three questions are mentioned above, and the specific answers are made by sheet metal processing plants running under Wuxi High.
1. Sheet metal processing, the number of processing tolerances is large, so in terms of processing difficulty, is it larger or smaller?
For this problem, the answer is that the sheet metal processing factory is running at high speed in Wuxi. The higher the processing dimension tolerance level is, the less difficult it is to process. Because the level of the number and the allowable range of the average size are larger tolerance values, it reduces Its difficult.
2. Different materials, among which metal processing in the table?
In this way, the sheet metal processing factory in Wuxi's high operation view needs to focus on learning and knowledge. Because of its high availability, it cannot be treated sloppy.
Cold-rolled sheet: advantages in applications, mainly for simplicity and low cost, however, taking into account the specific circumstances.
Hot-rolled sheet: mainly used for electroplating and paint, but because of difficulty, it is mainly based on sheet metal.
Galvanized steel: Surface treatment is usually not, and its cost is not low.
Aluminum profile: mainly used in some more complex materials in sub-rack.
Stainless steel: Surface treatment is usually not, and it costs more.
3. Surface metal sheet processing audit, is it what you need to see?
This question was run by a sheet metal processing plant in Wuxi Gao, and their answer was answered as follows:
Surface, standard size relationship view, clear key size required for assembly relationship between assembly and assembly. In addition, the quality and materials, as well as the technical requirements for these aspects, are also specified and cannot be omitted.